Acquired Jan 2025. Home Page – https://support.mybirdbuddy.com/hc/en-us
To change wifi or pairing start over;
- Log Out of the app and log back in.
- To shut down and restart the camera hold down the button on the camera until the red LED flashes and turns solid.
- Then select pairing and redo the setup with any changes.
With it outside the kitchen window, it must connect to the wifi extender using the same password as the main wifi.
Below from – https://support.mybirdbuddy.com/hc/en-us/articles/13076331322385-Quick-Start-Guide
The Bird Buddy camera module is powered by a 3800 mAh rechargeable Lithium-Ion battery.
The module that also houses the battery is fully detachable, so you can easily charge it with the USB-C to USB-C cable included in every order. You can always check the status of your battery, no matter where you are, right from the Bird Buddy app (in the Settings).
The time to fully charge the camera module will depend on how you charge it. Charging via an outlet adapter will be faster than charging it via a computer port. It takes about 2-4 hours for the module to be fully charged if you use a wall adapter (you should see a faint red blinking light that indicates it’s charging). Once the module is fully charged, you should see a faint solid green light on the module. If this is your first time charging Bird Buddy, it might enter pairing mode automatically so you will see a blue blinking light.
Our battery has overcharge protection, which means that when it reaches 100% charge, it will stop charging for a little while until it reaches 93-97%, then start charging again. The most recent battery state is sometimes not immediately visible in the app, try refreshing the main settings page (by swiping down on the screen) to get the most recent reading from the server.
LED Light Guidance
Green
3 rapid blinks: Wi-Fi is connected.
Solid green light: The battery is fully charged.
Red
1 rapid blink: The device has been turned off.
3 rapid blinks: The battery level is low and the device will turn off.
1 blink every 8 seconds: The device is currently charging (not active when in the housing).
Blue
Steady blinking: The device is ready for pairing. This can override the charging indicator lights.
Solid blue for 2 seconds: The pairing via Bluetooth was successful.
Orange
3 rapid blinks: The Wi-Fi connection has failed.
White
Steady blinking: The Wi-Fi connection is pending.
White & Green
1 white blink, then 1 green blink: The device is turned on.
Purple
Steady blinking: Firmware update is in progress.
Yellow
Steady blinking: Your device is currently pairing to your account.