This frame was last used by Dad with 4″ PVC pipe over the smaller rear toolbar. For parts try:
- See Quality Farm Supply for clamps here.
- See Ferguson Mfg. for similar parts.
- 12-inch disc Hiller with a 16-inch shank – Shank diameter: 1-3/16 in.
- Clamps for diamond toolbar here at Pacific Ag Wholesalers.
Dimensions
- Main Tool Bar – Diamond 2-1/4″ square x 48″ long
- There is 11″ on the main toolbar extending beyond the lower hitch braces on each side.
- Extensions – 3″ wide x 1-1/2″ deep x 18-1/2″ from the center of the diamond toolbar to the end of the extension.
- Rear Tool Bar – 1-1/4″ square x 65″ long
